shawnhu Posted February 4, 2016 Share Posted February 4, 2016 I have used them on lots of guns but I have been switching everything over to DNZ's and they are awesome. DNZ and Talley's are nice rings. X-Calibur Lighting Systems http://facebook.com/XCaliburLightingSystems Quote Link to comment Share on other sites More sharing options...
wildcat junkie Posted February 4, 2016 Author Share Posted February 4, 2016 So, what are DNZs? Quote Link to comment Share on other sites More sharing options...
wildcat junkie Posted February 4, 2016 Author Share Posted February 4, 2016 (edited) So, what are DNZs? OK I googled.2 things going against them. 1 They are aluminum & would look out of place on a classic Mauser. 2 They don't list an application for Mausers. Edited February 4, 2016 by wildcat junkie Quote Link to comment Share on other sites More sharing options...
Buckmaster7600 Posted February 8, 2016 Share Posted February 8, 2016 Have you shot it with the new scope yet? What do you think? Quote Link to comment Share on other sites More sharing options...
wildcat junkie Posted February 8, 2016 Author Share Posted February 8, 2016 (edited) Have you shot it with the new scope yet? What do you think? Weather has tuned nasty. When it was warm, the wind was blowing, now it's going sub-zero. I shot a few rounds off the deck the other day to get it on the paper. It was about 4" high @ 25yds & 1" left although shooting off the door jamb I think I pulled the shot left. I adjusted the elevation & shot @ a football size rock on the bank from 60yds & hit it pretty much center. I'm going to load up some 8X57 tomorrow so I'll be ready for the 1st decent day to go to the range. I did find something interesting when I pulled the 3-9x42 Kales off. It was shooting a bit erratic last fall & I found a pinhead sized spot where the anodizing was worn off the bottom of the objective bell. I think it was contacting the front edge of the front base ever so slightly. I sold the VX-2 3-9x40 that was on the Mauser last season (2014) to a kid that bought the 7mm-08 AXIS-II & put the Kales on the Mauser last winter. It shot its usual boring <1/2 cloverleafs immediately after the swap. When I went out to verify the zero this last fall it was occasionally throwing flyers out about 2". I'm thinking that the scope contact was the culprit. I wish they hadn't used the wide duplex on the untralight. I used the duplex gap subtension as a range estimator. The gap on the 3-9x33 is 18" @ 100yds when @ 9x! The 3-9x40 was 6" Edited February 8, 2016 by wildcat junkie Quote Link to comment Share on other sites More sharing options...
wildcat junkie Posted February 17, 2016 Author Share Posted February 17, 2016 Weighed the Oberndorf classic Mauser W/the 3-9x33 Leupold Compact scope the other day. All up weight, rifle, scope, mounts, & sling, 7# 12oz. Not bad for a rifle W/a 23 1/2" barrel. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.