Made some mods to my bow work station .

[rob-c]

So I built/ welded the bow stand / draw board several years ago, I modified my old apple press into a X-type press at that time also . It was originally in my garage/ workshop, so when I moved to my oldest boys old bedroom a few years ago it was a little too big. So I cut about 16 inches of the length off the draw board and added the arrow spine tester to the upper bar ( the rollers are held on with wing nuts so I can remove them when I use the draw board) .  Moved  my arrow saw to the bottom bar, added the swing arm for my bow vice. And put wheels on it so I can spin it to use either side. I had all the square tubing laying around and coated it in bed liner. I have to finish the weight for the spine tester yet. I did splurge and bought a digital gauge for my spine tester though . Super happy how it turned out 

Edited December 27, 2020 by rob-c

[rob-c]

[Swamp_bucks]

Nice setup.  

[The_Real_TCIII]

Very nice!


Sent from my iPhone using Tapatalk Pro

[2012_taco]

I hear Tim Allen grunting as I read this!! Very nice! I wish I knew what to do with 1/2 of what you have there!

[rob-c]

Thanks all , things were getting crowded in the room and I wanted to make a all In one bow work station. Next I’m going to rebuild my reloading bench  and have a custom quick  change receiver  in mind, so  my reloading presses are not bolted in the way.