Right right right...wrong!!!

[crappyice]

How do I adjust my single pin site left and right? Unfortunately the site is 4 years old and I can find no markings or labels to tell the make of site so this may pointless.

Sent from my iPhone using Tapatalk

[crappyice]

How do I adjust my single pin site left and right? Unfortunately the site is 4 years old and I can find no markings or labels to tell the make of site so this may pointless.

Sent from my iPhone using Tapatalk

Here's a pic of that helps you help me!


Sent from my iPhone using Tapatalk

[The_Real_TCIII]

loosen that bag allen screw on the bottom and move the housing

[DirtTime]

4 minutes ago, The_Real_TCIII said:

loosen that bag allen screw on the bottom and move the housing

Yep. What TC said.

[crappyice]

Tried that with no success.


Sent from my iPhone using Tapatalk

[crappyice]

Tried that with no success.


Sent from my iPhone using Tapatalk

Seems like there is a small screw inside housing that may control left right- is that possible



Sent from my iPhone using Tapatalk

[Merlot]

As mentioned before, that big allen screw at bottom should be the way to go...maybe a gentle tap will move the housing.

[DirtTime]

It might just be stuck. Sitting for 4 years can do that. But, I am pretty sure what TC said is right, loosen that bolt and it should move side to side.

If you remember the brand and model look it up and see what the makers say. 

Edited August 24, 2016 by ....rob

[The_Real_TCIII]

13 minutes ago, crappyice said:

Seems like there is a small screw inside housing that may control left right- is that possible



Sent from my iPhone using Tapatalk

Try that, seems like that threaded bolt is in there for a reason

[philoshop]

The black p-shaped part is a clamp. Loosen the screw holding that clamp. It will probably take a bit of force to to move the sight because it will likely be wedged in there pretty good. Remember that moving that sight to the right will move the point of impact to the left, and vice versa.

[sweet old bill]

Quote

 

If you shoot the arrow and it hits to the left of the target spot, then you have to move the sight to the left, if the arrow hits to the center of the spot you are shooting at but is low then you move lower the sight and this will raise were the arrow will hit.

[fasteddie]

What Sweet Old Bill said ..........

[crappyice]

Thanks guys...that internal screw was key but to access it I need to remove the black cap where those two small nuts are. Then I loosened the p clamp and was able to back out the internal screw enough the shift the housing to the right. Flying true..confidence restoring!


Sent from my iPhone using Tapatalk

[WNYBuckHunter]

Thats the most convoluted way to adjust a site Ive ever heard of. I wish I knew what brand it was so I can avoid it at all costs.

[dbHunterNY]

On ‎8‎/‎24‎/‎2016 at 3:57 PM, crappyice said:

Here's a pic of that helps you help me!


Sent from my iPhone using Tapatalk

Sounds like you got it figured out.  Does it say "Impact Archery" on the sight housing?  if so, do you like that big bright pin?  it obviously works so don't take that as me knocking your sight.  I haven't actually shot one.  I'm thinking it's 3x the diameter of the fiber I shoot and wrapped still.