stuck shot gun choke

[land 1]

Any tips or tricks in getting a stuck choke tube out of shotgun , choke has been my 870 for lots of years and i cant budge it....

[rob-c]

One thing to try is get a can of Kroil penetrating oil spay and  let it sit and work . 

Edited March 23 by rob-c

[airedale]

Penetrating oil as mentioned above is good for starters. Heat will get help them loosen, don't use a torch, a hair dryer works best. There are also choke removal tools made for stuck chokes.

Al

[LET EM GROW]

Kroil or a good industrial strength penetrating oil and let it soak. you may have to jeapordize the choke to get it out. If that doesnt work, add a low amount of heat to the barrel and not so much the choke. Your choke has expanded from shots. 

[CharlieNY]

This video should help you out. Good luck.    

 

[Nytracker]

Kroil  is a true miracle worker for freeing up heat stressed and rusty bolts . Also works to keep rust off tools in the garage. I run a spirits of that in all my air tools also.

[land 1]

thks guys will give it a shot waiting on new choke wrench now bent the old one that came with gun

[DoubleDose]

FWIW, some mechanics say a 50:50 mix of acetone and automatic transmission fluid (ATF) is superior to Kroil. 

[land 1]

wasnt pretty but got it with out damaging barrel choke is toast tho, long story short slightly moved it with  choke tool i got but both tool and choke stripped and tool would not grip, so found a chisel just about 12 ga size tapped it down and that bit into walls of choke and was able to unscrew it . I did soak it in penetrating oil 3 days also

Edited March 25 by land 1

[fasteddie]

1 hour ago, land 1 said:

wasnt pretty but got it with out damaging barrel choke is toast tho, long story short slightly moved it with  choke tool i got but both tool and choke stripped and tool would not grip, so found a chisel just about 12 ga size tapped it down and that bit into walls of choke and was able to unscrew it . I did soak it in penetrating oil 3 days also

Did that mess up the threading on the barrel ? 

[land 1]

no on most remington guns the threading is at the bottom of the choke , not right at the end of the barrell, only drove the the chisel down maybe  1/2 -3/4 of an inch,an the chisel never mad contact with barrel either just the choke 

Edited March 26 by land 1

[airedale]

Hey land1, good to see you got that choke out.

Al

Edited March 26 by airedale

[land 1]

thanks wont make the mistake of leaving one in long term again .......